You are offline, the product will be added to cart once you are online on product availability
The products are being added to cart which are added while offline
Previous Next
Winding a Bobbin

Winding a Bobbin

 

Winding a bobbin is quick and easy when you follow the directions below. Always wind the bobbin before threading the machine and needle.

Winding a bobbin

 

1. Place spool of thread on spool pin.

2. Slide spool pin holder/cap firmly over the rim of spool to prevent the thread from tangling.

3. Push bobbin winder pin to the far left if it is not already there.

 

4. Pass the thread from the spool through thread guide as shown (illustration 1).

Place spool of thread on spool pin.

 

5. Pass thread end, from inside, through the small hole in the rim of the bobbin (illustration 2).

Slide spool pin holder/cap firmly over the rim of spool

 

6. Place bobbin onto the pin.

7. Push bobbin winder pin to the right (illustration 3). This will stop the needle from moving.

Push bobbin winder pin to the far left

 

8. Holding thread end, step on speed controller to run the machine until the desired amount of thread is wound. (Winding stops automatically once bobbin is full.)

9. Cut thread; push bobbin to the left and remove it from bobbin winder pin (illustration 4).

Cut thread and push bobbin to the left

 

10. Trim thread ends from top of the bobbin.