Silverware Holder with Personalized Card Insert

Shopping List Notes:

The fabric requirements listed below accommodate a table knife that measures 8” (20cm) in length. If your table knives are longer than 8” (20cm), you should adjust the length of the fabric, batting for the silverware body pieces, and as well as the fabric and stabilizer for the pocket.

Supplies listed are for making one silverware holder, so adjust the fabric requirements as needed for the number of holders you want to make. Also, the silverware holders shown accommodate a table knife that measures 8” (20cm) in length. If your knives are longer than 8” (20cm) add the necessary length to the silverware body front and back pieces, as well as extending the length of the pockets.

o Cut one fabric for silverware body front: 5” x 10” (12.7cm x 25.4cm)

o Cut one fabric for silverware body back: 5” x 10” (12.7cm x 25.4cm)

o Cut one fabric for pocket front: 5” x 5” (12.7cm x 12.7cm)

o Cut one fabric for pocket lining: 5” x 5” (12.7cm x 12.7cm)

o Cut one fusible batting 4½” x 9½” (11.5cm x 24.1cm)

o Cut one fusible interfacing 5” x 5” (12.7cm x 12.7cm)

o Cut one piece of vinyl 3¼” x 2¼” (8.3cm x 5.7cm)

o All-purpose sewing thread

o Decorative thread for sewing around vinyl

o Rotary cutter, mat and ruler

o INSPIRA™ Tear-A-Way™ stabilizer

o Hand sewing needle

o Point turner or stiletto

o Non-stick foot

o Blind hem foot

o Satin stitch foot (optional, if using built-in lettering on machine for text on cards)

o Tape (to hold vinyl in place while decorative stitching)

o Card stock paper (to make place card inserts)